These are based off of my Keychain tool the Toucan which is essentially this tool but has a cutting edge at the opposite end of the prytip. (I included a pic just so you can get an idea of the original and where these come from)
Anyhow..I had some requests about these being made in Ti, so here they are.
These are made from .100" 6AL/4V Titanium
This batch measure about 1 7/8" in length
They are 55.00 (+3% paypal) shipped in the Cont. U.S.
Numbered from left to right in the first pic below.
1.) Large Jimping on Spine
2.) Full coin edge (small jimping all the way around)
Thanks for looking and thanks for your support!
These are listed on multiple forums so time stamp rule applies!