here are the blanks cut out (multi steels)
ground for HT
and grinding finished on 6 and handles picked otu
here are the blanks cut out (multi steels)
ground for HT
and grinding finished on 6 and handles picked otu
L R Harner (butch)
www.harnerknives.com (still getting it all set up but its working)
I can't wait for more!!
The best DAMN FORUM period!!
Looks Great!That should keep you busy for a couple of days.
sure will and i have to redo a few of the blades that didnt make it throu HT
L R Harner (butch)
www.harnerknives.com (still getting it all set up but its working)
how bout a crappy phone pic of 5 of the tanges set into the handle blocks
L R Harner (butch)
www.harnerknives.com (still getting it all set up but its working)
temp pins are in and part way shaped out handles. spines and heels are rounded and blades are ready for marking then epoxy and final fit up
L R Harner (butch)
www.harnerknives.com (still getting it all set up but its working)
4 of them getting realy close and 2 not far behind
L R Harner (butch)
www.harnerknives.com (still getting it all set up but its working)
Coooool.
here they are (ok so its not all of them finished but its a start)
L R Harner (butch)
www.harnerknives.com (still getting it all set up but its working)
Very nice Butch!
more picturees
hammered copper fittings
L R Harner (butch)
www.harnerknives.com (still getting it all set up but its working)
That is a sweet ass handle.Love the copper.
How do you round the very edge of the copper on that hammered fitting?
on the slack belt part of a the flat platten at about a 45 degree angle
L R Harner (butch)
www.harnerknives.com (still getting it all set up but its working)
beautiful.
I had a compass, but without a map, it's just a cool toy to show you where oceans and ice are.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks