View Full Version : On the the bench 12/17/08
Here is some stuff ready to go to heat treat. Hope to get it back late tomorrow.
2 of the Wyverns in S30V. small and a larger one.
2 Azrael Flipper blades in ATS34
Piece of scrape left from cutting out the folder blades. I thought it might look like a neck knife with some finger grooves so It's off to heat treat as well.
12-17-2008, 01:18 PM
Like the looks of those.:devil1:
12-17-2008, 01:43 PM
Pics! Pics! Many, many, detailed pics of EVERY single step of the process.
12-18-2008, 05:07 PM
Hey ya big pimp! Good looking stuff!:trustme:
Here is one. Needs a small lanyard at the end to hold onto. Yes it glows in the dark.
Whoah!! Moonglow slabs!!! :firedevil Good job bro!!
Sam :leatherdevil :
I'll almost be glad when the holidays are over so I can get back on a regular schedule.
Flathead screws on the rear so they will be under the scales, Ti bolsters are almost done.
12-25-2008, 12:50 PM
Hope to have the lock cut tomorrow and see if I can wrap this one up by tomorrow night.
12-26-2008, 09:15 AM
That's damn hot buddy!
12-26-2008, 01:11 PM
Good lookin stuff there Will
Thanks. Managed to break the pilot off of the counterbore so I guess there is no chance of getting this done till the tool shop opens again.
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.